Westcott 2334 User Manual

Light Modifiers  
Page 1 of 2  
Setup Instructions  
Apollo Light Modifiers  
Style: 2334 (28” Apollo); 2335 (28” Apollo Mono); 2218 (Mini Apollo); 2348 (JS Apollo)  
Description  
The Westcott Apollo™ and Apollo™ Mono are built on umbrella frames. There is no need for speed  
rings, simply use the umbrella receptacle on your light. Easy opening and closing means easy set-up  
and takedown. The square or rectangular shape allows you to scrim or control the light more readily and  
allows 104 degrees of light spread  
Product Contains  
ƒ [1] Apollo  
(Style 2335 will also contain an additional mounting bracket)  
Instructions  
To mount the standard Apollo™ light modifier onto your light, open the zipper at the bottom of the unit.  
Open the white diffuser panel. The white diffuser panel has hook and loop tape on the sides and bottom  
and is sewn across the top. This allows for easy access to the inside of the light modifier. Open the  
Apollo™ like an umbrella. On the smaller models, such as the #2218 Mini Apollo, it is helpful to push  
slightly against the top of the unit with one hand while raising the slider up the center shaft to click into  
place.  
After the Apollo™ is open, slide the shaft through the umbrella receptacle of the light. Tighten the  
setscrew onto the shaft. Do not over tighten! This could damage the umbrella shaft. After the  
Apollo™ is secure, drop the diffuser panel down and fasten the hook and loop tape together. Close the  
bottom zipper opening around the light stand or boom arm.  
Directional light examples: For direct diffusion, position light facing the white diffuser panel. The  
light will have a bright center with a softer edge. The distance of the light to the diffuser panel will  
govern the brightness of the center of the light. Caution: positioning the light or other hot objects too  
close or in contact with the fabric of the Apollo may cause damage. For indirect diffusion, mount the  
Apollo™ with the light facing towards the back of the light modifier. With the light in this position,  
light will bounce off the silver metalized back of the unit and produce a more uniform, softer light.  
To mount the Apollo™ Mono to the light, unscrew the umbrella-mounting block from the mounting rod.  
Place the mounting bar through the umbrella receptacle with the black plastic ball handle on the outside  
of the Apollo™. Please note that the mounting rod has a flat edge for the setscrew in the mounting  
block to lock onto and prevent the block from turning. Replace the umbrella receptacle on the end of the  
mounting rod.  
Questions? Please call 800.886.1689 or email [email protected].  
©F.J. Westcott Company  

Weil McLain PD Gas Series 3 User Manual
Vivitar ViviCam F332 User Manual
U Line 30 User Manual
Soundstream Technologies EXC 12 User Manual
Sony SSC DC334 User Manual
Sony DCR HC19E User Manual
Sony CDX M9900 User Manual
Sony 5500 User Manual
SanDisk 41DVN User Manual
Samsung VP D 130 User Manual