Xantech Universal Remote 284D User Manual

MODEL  
ATTACHING THE EMITTERS TO OTHER LOCATIONS  
The high output from the curved top side of the emitter permits control  
from as much as 3 feet away when on the axis of the IR sensor  
window of the component.  
This allows placement on surfaces just below, above or in front of the  
controlled components for a more pleasing aesthetic appearance.  
Choose a location on a cabinet shelf, door, etc., as shown in Figs. 3b,  
c and d. Be sure the edge of the component does not block the IR  
signal (Figs. 3c and d).  
284D  
Dual Designer Emitter  
INSTALLATION INSTRUCTIONS  
DESCRIPTION  
The 284D Designer Emitter each contain a tiny infrared LED housed in a  
miniature, designer styled, black appearing, injection molded plastic shell.  
They emit IR (infrared) control signals sent to them by IR receivers or other  
Xantech controllers. The 284Ds can be installed directly on the IR sensor  
window of the controlled devices or other suitable location.  
CAUTION: Cabinet door locations (Fig. 3b) will usually result in interruption  
of the IR control signals to the components when the door is open.  
CONNECTING THE EMITTERS  
Simply insert the mono mini plug of the 284D emitter into the  
“EMITTERS” or “OUT” jacks on any of the Xantech Connecting  
Blocks or Controllers.  
CAUTION: DO NOT plug emitters into the IN/OUT or HIGH OUT  
jacks on the 790-00 and 791-44 Connecting Blocks. To do so will  
destroy the emitters!  
INSTALLATION  
ATTACHING THE EMITTERS TO IR SENSOR WINDOWS  
Each emitter has a clear adhesive layer on the bottom flat surface of  
the shell.  
Simply peel off the adhesive cover and affix the emitter to the center  
of the IR sensor window on the controlled component’s front panel.  
In some cases it may be difficult to find the location of the IR sensor  
on the component. Consult the owner’s manual of the unit, or the  
manufacturer, for the exact IR sensor window location.  
Double-sided adhesive tape is included. If you move the emitter to a  
different component, use this tape to replace the current adhesive  
layer for the best adhesion.  
The shell, though dark in appearance, is transparent to infrared light,  
allowing commands from a handheld remote control to pass through  
it. This permits direct control of the equipment from a handheld  
remote as well as from the 284D.  
Limited Warranty  
Xantech® warrants its products to be free of defects in materials or  
workmanship. This is a Limited Lifetime warranty from the date of purchase  
by the original consumer. Any products returned to Xantech and found to  
be defective by Xantech within the warranty period will be repaired or  
replaced, at Xantech’s option, at no charge. Xantech will not be  
responsible for the actual cost of installation or removal of the product, nor  
for any incidental or consequential damages. Some states do not allow the  
exclusion or limitation of incidental or consequential damages, so the  
above limitation may not apply to you. This warranty gives you specific  
legal rights. You may have additional legal rights that vary from state to  
state.  
BLACK (IR OPAQUE) EMITTER SHIELD  
An optional shield, available from Xantech as model 28DES, fits over  
the emitter head and the sensor window of the controlled component.  
It prevents unwanted external IR signals from passing through or  
leaking past it.  
Xantech Corporation  
13100 Telfair Ave. 2F, Sylmar CA 91342 | Xantech.com  
Installation Instructions, 284D © 2008 Xantech Corporation  
Document # 08905168A  
This document is copyright protected. No part of this manual may be  
copied or reproduced in any form without prior written consent from  
Xantech Corporation. Xantech Corporation shall not be liable for  
operational, technical, or editorial errors/omissions made in this document.  
Use the 28DES when you want the equipment to respond only to the  
284D, such as in zone controlled systems.  
 

Weed Eater Trimmer 545186833 User Manual
Wenger Watch 543103 User Manual
Weslo Treadmill WATL139060 User Manual
Westinghouse Model Vehicle EW40t4FW User Manual
Whirlpool Clothes Dryer 8528146 User Manual
Whirlpool Cooktop W10545672A User Manual
Whirlpool Trash Compactor GX900QPPB1 User Manual
Yamaha Musical Instrument Amplifier DG130 User Manual
Zanussi Clothes Dryer TE 301 A User Manual
Zanussi Convection Oven 240204 User Manual