X10 Wireless Technology PDAs Smartphones HR12A User Manual

F.C.C. CAUTION - THIS DEVICE COMPLIES WITH PART 15 OF THE  
FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO  
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL  
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY  
INTERFERENCERECEIVED,INCLUDINGINTERFERENCETHATMAY  
CAUSE UNDESIRED OPERATION. NOTE: NO CHANGES OR  
MODIFICATIONS MAY BE MADE TO THE UNITS. ANY CHANGES  
MADE TO THE UNITS WILL VOID THE USER'S AUTHORITY TO  
OPERATE THE EQUIPMENT.  
Installation and operating instructions for HR12A PalmPad  
The HR12A PalmPad Remote Control sends Wireless Radio  
Frequency (RF) signals to an X10 Transceiver (RR501 or TM751)  
or any X10 security system base receiver. The receiver then passes  
the signals onto your house wiring to control lights or appliances  
around your home. You plug lights and appliances into X10  
Modules (sold separately). The PalmPad also works with the  
CM11ATwo-WayComputerInterfacetoinitiatemacros(routines)  
so you can set up a “coming home” routine which is initiated when  
you press a button on the PalmPad.  
1. Install 4 AAA alkaline batteries (sold separately) in the  
PalmPad’s battery compartment.  
X10 Wireless Technology, Inc. LIMITED 1-YEAR WARRANTY  
2. Use a dime to set the Housecode dial to match the X10 Modules  
and Transceiver you want to control.  
3. PluginanX10Transceiver(RR501orTM751,soldseparately).  
4. Set the Palm Pad’s slide switch to 1-8 to control X10 Modules  
set to Unit Codes 1 thru 8.  
5. Set the slide switch to 9-16 to control X10 Modules 9 thru 16.  
6. PressthecorrespondingONorOFFbuttontoturnX10Modules  
on and off.  
X10.com, a division of X10 Wireless Technology, Inc. (X10) warrants X10 products to be  
free from defective material and workmanship for a period of one (1) year from the original  
date of purchase at retail. X10 agrees to repair or replace, at it’s sole discretion, a defective  
X10 product if returned to X10 within the warranty period and with proof of purchase.  
If service is required under this warranty:  
Return Merchandise Authorization (RMA) number.  
2. Return the defective unit postage prepaid to X10 (see address on back).  
3. Enclose a check for $4.00 to cover postage and handling.  
4. Enclose a dated proof of purchase.  
7. To brighten or dim lights connected to X10 Lamp Modules and  
Wall Switch Modules, first press the corresponding number  
button, then press the UP or DOWN (blue) buttons.  
5. X10 is not responsible for shipping damage. Units to be returned should be packed  
carefully.  
to complete your on-line warranty registration. Thank you.  
HR12A-9/01  
 

Weed Eater Trimmer 530086930 User Manual
Weider Home Gym WESY59833 User Manual
Whirlpool Refrigerator 2204658 User Manual
White Rodgers Home Theater Server 47D43 811 User Manual
White Rodgers Marine Heating System 37 5488A User Manual
Wolf Range FS 36 User Manual
Xantech Network Router RS2321X8 User Manual
Xantrex Technology Power Supply PROwatt 1000 User Manual
Zanussi Electric Pressure Cooker ZKG5540 User Manual
Zanussi Refrigerator 178178 User Manual